Operation; Saving Energy - Dometic C 35F Mode D'emploi

C35F, C55F, C75F
6.4 Connecting the wine cooler
Observe the following when connecting the wine cooler:
• Leave the wine cooler to stand upright for about 2 hours after transporting,
before you connect it to the power supply. Otherwise this could cause faults in
the cooling system.
• Connect the wine cooler to a circuit that is protected with 15 A.
• Have the socket and power circuit checked by a qualified electrician to ensure
that the socket is earthed correctly. Do not use an extension cable or a multiple
power socket.
• The power cable must rest securely behind the wine cooler and not be allowed
to lie or hang unprotected.
• Ensure that the power cable is not jammed when pushing the wine cooler into
place.
7

Operation

7.1 Before first use
Before first use, clean the wine cooler inside and outside with a damp cloth for
hygienic reasons (see also chapter "Cleaning and maintenance" on page 24).
7.2 Storing bottles
Please note the following:
• Only store wine in wine bottles that are closed and still sealed.
• Do not overload the wine cooler.
• Do not cover the shelves with aluminum foil or any other objects, as this obstructs
the air circulation.
• After a power cut or if the wine cooler has been switched off, wait 3 to 5 minutes
before switching on the wine cooler again.
➤ Position the bottles as shown in fig. 5, page 5 to fig. 8, page 7.
7.3

Saving energy

• Only open the wine cooler as often and for as long as necessary.
• Avoid unnecessarily low temperature settings.
EN
Operation
19