Check carefully if there is no longer any fire on the surface.
Warning: Never fill a burning burner – Peril to life!
Wait at least 30 minutes for the Bio Flame Burner® to cool down.
For further instructions see: 'How to fill the Bio Flame Burner®"
Lighting the Bio Flame Burner®
There is a latch for the fire-opening on the topside of the Bio Flame Burner®
When the Bio Flame Burner® is not lit, this latch is closed.
By opening the latch the fire-opening with the ceramic brick becomes visible.
The Bio Flame Burner® can be lit with a lighter or a long matchstick, but only when there is
nothing placed on the filling-opening and the Ruby Fires bio ethanol 98% is well filled as
described in: 'How to fill the Bio Flame Burner®'
Opening and closing the latch:
You can either by hand or with the utensils open or close the latch
Maintenance
When the Bio Flame Burner® has been used very often, discolorations on the top can exist.
This is normal and the quality of the product remains the same.
Do not use an abrasive product for cleaning the insert. Clean the surfaces with a moist piece of
cloth or a non-abrasive stainless steel cleanser.
Possible problems and solutions
Problem
Existence of soot
Duration of fire too short
Duration of fire too short
Flames too high
Flames too low, not visible Burner has not been filled
Burner makes a rustling
noise
Flames are blue, not
Burner closed
Possible cause
Wrong fuel
Fire-opening is covered with
decoration material
Wrong fuel (e.g. gel)
Burner has not been filled
completely
Wrong fuel
completely
Wrong fuel (e.g. gel)
Fuel is almost finished
Solution
Use ONLY Ruby Fires bio ethanol 98%
Make sure the fire-opening is free of
decoration material
Use ONLY Ruby Fires bio ethanol 98%
Extinguish the burner. Let it cool
down for 30 minutes and then re-fill.
Use ONLY Ruby Fires bio ethanol 98%
Extinguish the burner. Let it cool
down for 30 minutes and then re-fill.
Use ONLY Ruby Fires bio ethanol 98%
Extinguish the burner. Let it cool