Technical Data; Ambient Temperature - Electrolux ERD24303X Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. When defrosting is completed, dry the interior
thoroughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the
maximum coldness and run the appliance for
two or three hours using this setting.
7. Reload the previously removed food into the
compartment.
What to do if...
Normal Operating Sounds
• You may hear a faint gurgling and a bubbling
sound when the refrigerant is pumped through
the coils or tubing. This is correct.
• When the compressor is on, the refrigerant is
being pumped around and you will hear a whir-
ring sound and a pulsating noise from the com-
pressor. This is correct.

Technical data

Dimension
Rising Time
The technical information are situated in the rating
plate on the internal left side of the appliance and
in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct operation
of the appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambi-
ent temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate

Ambient temperature

class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the fig-
ure.
Important! Never use sharp metal tools to scrape
off frost from the evaporator as you could damage
it. Do not use a mechanical device or any artificial
means to speed up the thawing process other than
those recommended by the manufacturer. A
temperature rise of the frozen food packs, during
defrosting, may shorten their safe storage life.
• The thermic dilatation might cause a sudden
cracking noise. It is natural, not dangerous phys-
ical phenomenon. This is correct.
• When the compressor switches on or switches
off, you will hear a faint "click" of the temperature
regulator. This is correct.
Height
Width
Depth
1. Fit the spacers into the holes. Make sure that
1404 mm
545 mm
604 mm
19 h
the arrow (A) is positioned as shown in the pic-
ture.
electrolux 13

Publicité

Table des Matières
loading

Table des Matières