Technical Data; Installation - Electrolux ERB29033X Notice D'utilisation

Problem
The lamp does not work.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre.
Replacing the lamp
If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.

Technical data

Dimension
Height
Width
Depth
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
ERB29033X ERB34033X
ERB29033W ERB34033W
1540 mm 1750 mm
595 mm 595 mm
632 mm 632 mm
20 h 20 h
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Refer to "Replacing the lamp".
2
3
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Force Cen-
ter.
ERB36033X
ERB36033W
1850 mm
595 mm
632 mm
20 h
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
electrolux 25
Solution
1
ERB40033X
ERB40033W
2010 mm
595 mm
632 mm
20 h