Technical Specifications - Velleman CHLSC1 Notice D'emploi

9. Troubleshooting
 Controller is not working, no LEDs
Check the input connections and controller input voltage.
Press the ON-button on the remote control.
 Status LEDs are OK but no output.
Check the output connections and controller input voltage.
 Output brightness too low
Check the output connections and controller input voltage.
 Overheating of the controller
Make sure the controllers' input voltage is not too high and check whether
there is sufficient ventilation.
 In linked mode, controllers don't work synchronously.
Check the data terminals and the length of the data bus. Press any key on
the remote control to start synchronizing.
 Remote control is not working
Point the remote control straight towards the IR receiver, check the
distance (<7m). Replace the battery.

10. Technical specifications

input voltage
output power
max. output for each loop
IR remote control working distance
dimensions
Weight
power supply remote control
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 03 – 12/11/2015
Controller
IR remote control
Controller
IR remote control
CHLSC1
12 or 24VDC
180W (12VDC) or 360W (24VDC)
60W (12VDC) or 120W (24VDC)
7m
121 x 51 x 26mm
90 x 49 x 7mm
±110gr
±22gr
3V lithium CR2025, incl.
7 ©Velleman nv