Overview And Use - Velleman CHLSC1 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
 Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
 Do not use outside the technical specifications (see §10).
Features
4.
 for CHLS-series
 4-line, 3-loop RGB controller with remote control
 controlled by push switch on the unit or through infrared remote (incl.)
 20 pre-programmed output modes (single colours, flash, strobe, fade,...)
 high load capacity
 comes with screws and self adhesive strip on the backside for easy
installation
5.

Overview and use

Refer to the illustrations on pages 2 and 3 of this manual.
LED Controller
1 IR receiver
2 RED status LED
3 GREEN status LED
4 BLUE status LED
5 Function select button
6 DC in "+" (12V or 24V)
Remote control
A Brightness adjustment (3 levels)
B On/Off button
C Light colour selection keys
D Mode selection keys:
 FLASH: 7 colours flashing
 STROBE: R, G, B - 3 colours "strobe-mode" alternately
 FADE: 7 colours fading out and in
 SMOOTH: 7 colours fading out and in smoothly
6.
Installation
LED strips
 It is possible to connect either one RGB LED strip or 1 to 3 single colour strips
(red, green and blue). The LED strips can be either 12VDC or 24VDC driven.
Do not mix!
 First make sure all LED strips (not incl.) are securely in place.
 Mount the controller by using the adhesive tape on the back and the included
screws. Only install the device in a dry and easily accessible location with
sufficient ventilation. Note that the IR receiver [1] must be visible to use the
remote control.
 Connect the LED strip(s) to the controller outputs. It is recommended to use
at least AWG 12 wire (Ø2.053mm). In case of an RGB-LED strip, connect the
common [10], the red [11], the green [12] and the blue [13] outputs to
the appropriate terminals of the LED strip. When using single colour LED
V. 03 – 12/11/2015
CHLSC1
7
DC in "-"
8
Data port "+"
9
Data port "-"
10 Output common "+"
11 Output RED "-"
12 Output GREEN "-"
13 Output BLUE "-"
5
©Velleman nv

Publicité

Table des Matières
loading

Table des Matières