Vimar ELVOX 41002 Manuel D'installation page 27

41002 - 41005
s. If this has been done previously, all 4 LEDs will blink to alert
you that you are changing a configuration that then cannot be
restored using the procedures stated here.
LED configuration Meaning
1 second (default)
5 seconds
All 4 LEDs are flashing:
Different value to the above
The (PREVIOUS) and
tween the possible values. If you try to go before the first or after
the last one, the speech unit will emit a tone to warn you that
there are no other valid values.
If you start from a configuration with the LEDs flashing, first
pressing the button (PREVIOUS) will set the first possible
value, while pressing the
possible one.
Pressing (DEL) takes you back to the previous level, with-
out saving any changes.
Press (OK) to confirm what you have chosen.
6. Conversation time
Through the procedure described here, the talk time can only
be set to the values of 2 (default) and 5 minutes. With SaveProg
other values are possible from 10 to 2540 s. If this has been
done previously, all 4 LEDs will blink to alert you that you are
changing a configuration that then cannot be restored using the
procedures stated here.
LED configuration Meaning
2 minutes (default)
5 minutes
All 4 LEDs are flashing:
Different value to the above
The (PREVIOUS) and
tween the possible values. If you try to go before the first or after
the last one, the speech unit will emit a tone to warn you that
there are no other valid values.
If you start from a configuration with the LEDs flashing, first
pressing the button (PREVIOUS) will set the first possible
value, while pressing the
possible one.
The self-start and response times have not changed, while
with SaveProg the call, self-start and talk times are all set in-
(NEXT) buttons change be-
button (NEXT) will set the last
(NEXT) buttons change be-
button (NEXT) will set the last
dependently.
Pressing (DEL) takes you back to the previous level, with-
out saving any changes.
Press (OK) to confirm what you have chosen.
7. Audio level
The audio level is configurable on 4 levels.
LED configuration
Pressing (DEL) takes you back to the previous level, with-
out saving any changes.
Press (OK) to confirm what you have chosen.
8. Reset factory settings / Restart / External
Memory Reset
LED configuration
On confirming "reset factory setting" with
speech unit will emit a continuous tone for 8 s. During this time
you need to press the
not completed, the speech unit will go into its rest state.
On confirming "restart entire system", the indoor unit will instruct
all the devices in the system in which it is installed to restart, af-
ter which it will itself restart. It is functionally equivalent to press-
ing the reset button on the Master speech unit of the previous
generations.
Confirming the External Memory Reset deletes any names in
the contacts list, entry codes and button remapping.
9. Default pushbutton grouping
By confirming with
EN
Meaning
Level 1
Level 2
Level 3 (default)
Level 4
Meaning
Reset factory settings (default)
Restart entire system
External Memory Reset
(contacts list, access keys,
remapping)
(OK), the
button (OK) 3 times. If this step is
(OK) you choose how the speech unit
27