Starter Will Not Operate - Yamaha F75 Manuel De L'utilisateur

1. Filter cup
2. Water detection switch lead
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01971]
8. Connect the water detection switch cou-
pler securely until a click is heard.
1. Water detection switch coupler
9. Fasten the water detection switch lead
with the plastic tie.
Trouble Recovery
1. Plastic tie
10. Install the top cowling.
11. Start the engine and make sure that the
water separator-alert indicator remains
off. Have a Yamaha dealer inspect the
outboard motor after returning to port.
EMU29543

Starter will not operate

If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started manually with
an emergency starter rope. However, the en-
gine cannot be started manually if the battery
voltage is low. If the battery is discharged to
9 volts or below, the electric fuel pump will
not operate.
EWM01023
WARNING
 Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
 When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
95