Philips PSD1111/10 Mode D'emploi page 13

Resetting signal
If the software of the Philips BlueControl no longer responds or if another
unexpected failure occurs, you can reset the Philips BlueControl.
1 Connect the Philips BlueControl to a wall socket with the adapter
or connect it to a USB port of a computer.
2 Press the on/off button for 5 seconds until the LED indicator
switches from green to blue. After the button is released, the LED
indicator shows the following signals in succession: 1. It briefly lights
up red and then goes out. 2. It lights up orange and goes out. 3. Then
the LED indicator lights up green briefly to indicate that the Philips
BlueControl has been reset and works normally again.
Battery level signals
When you press the on/off button and the LED indicator lights up solid
red and you hear 3 beeps, the battery of the Philips BlueControl is empty.
1 You have to charge the battery before you can start a new
treatment. Charge for at least 40 minutes to be able to complete
one full treatment.
Cleaning
Do not immerse the Philips BlueControl in water or rinse it under
the tap.
Always remove the Philips BlueControl from the strap before you put
the strap in the washing machine to clean it.
Caution: Clean the Philips BlueControl after each treatment to ensure
it continues to function properly.
1 Clean the Philips BlueControl with a damp cloth.
2 Clean the sensor with alcohol and a cotton bud at an ambient
temperature once a week.
3 The strap, the arm sling and the leg sling can be washed in the
washing machine.
Caution: To prevent damage to the drum of the washing machine,
to other laundry in the drum or the fabric of the strap, close the velcro
connections and wash the strap in a fine-mesh washing bag.
Note: Use a gentle cycle and a temperature of 30°C maximum. Dry the strap
and the slings on the air and not in a tumble dryer. Do not iron the strap and
the slings.
ENGLISH
13