Lubrication; Health And Safety - Elcometer Sagola 3300 GTO Manuel D'utilisation

13. Lubrication

The original lubrication of the gun is eliminated through use
and cleaning. In order to guarantee perfect operation, it is
necessary to grease the regulating or fastening threads,
friction areas, etc., on a periodic basis, especially after each
cleaning session and with greater care if the gun has been
cleaned in a machine. Moving parts must be lubricated light-
ly after cleaning has been completed.
We recommend you to use a light SAE 10 oil or natural grea-
se or vasoline.
It is important to check that the lubricant used does not contain components that might impair
the spraying quality (Silicones, etc.).

14. Health and Safety

In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the com-
pressed air distribution network.
• Safe disconnection from the compressed air network:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding con-
tainer. If the pneumatic connector is fitted in the air inlet, disconnect the hose from the pistol. If
it is not, depressurise the air hose properly and, using a spanner, unscrew the end of the hose
from the air inlet connector, holding the pistol firmly.
• Safe connection to the compressed air network:
If the pneumatic connector is fitted in the air inlet, connect the hose to the pistol. If it is not,
hold the pistol firmly and, using a spanner, screw the end of the hose into the air inlet connector.
Check there are no leaks.
• Safe disconnection of the product tank:
Carry out the cleaning according to point 14. Disconnect the tank by unscrewing the product inlet
connector, holding the body of the pistol firmly.
• Safe connection of the product tank:
Connect the tank by screwing on the product inlet connector, holding the body of the pistol firmly.
Check there are no leaks.
Never point the unit towards yourself, others or animals. The thinners and dilution
media used can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at
that time. After work has been completed, thinners and the product to be applied must be retur-
ned to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition (naked
flames, lighted cigarettes, etc.) in the working area as these might generate
easily flammable gases. Likewise, the approved protective means must be
used (breathing, hearing, etc.) in accordance with the regulations establi-
shed in this regard.
If the unit is used in an inadequate manner or its components are altered in any way severe
material damage may occur and bodily harm may be caused to the operator, other personnel
and/or animals and may even cause death. SAGOLA S.A.U. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
ENGLISH