Clean Air; Sufficient Volume Of Air - Elcometer Sagola 3300 GTO Manuel D'utilisation

Fig.04
Open the product regulator until the appropriate amount of product comes out. Now you have
the maximum spraying width (spraying pattern). You can reduce this according to your needs by
closing the spray width regulator (see Fig.5 and 6).
Please be sure that you put the spray gun properly by keeping its perpendicularity to the piece
to be painted in order to achieve the maximum transfer of the sprayed product and obtain the
best finishing quality.

9.1.- Clean Air

The air used for spraying must reach the gun free of impurities, aerosols, oil, silicone and solid
particles. To do this you must eliminate these with coalescent filter units.
The use of air treatment equipment with built-in pressure regulators is recommended
(SAGOLA 5200X, 5300X or 5300X Plus models).

9.2. Sufficient volume of air

A sufficient volume of air can be supplied to the gun by means of an air compressor of ade-
quate power (1HP equals 110 L/min approximately), a good compressed air network and by
avoiding pressure drops through the use of antistatic, silicon-free air hoses with a minimum
inside diameter of 8 mm. and resistant to the spraying air pressure (minimum 20 bar) and to
the aggressive effects of paint solvents. Before assembling the air network, you must check on
the air tightness of the hose.
Use antistatic air hoses. Should an antistatic air hose not be available,
you must attach the unit to a ground connection in order to eliminate
any static electricity.
The total derivative resistance must be <1 million Ohms.
Fig.05
ENGLISH
Fig.06