Forch Powerwash Bio Mode D'emploi page 65

ATTACHMENT 2 – REINSTALLATION OF
ELECTRIC KIT
Necessary tools: Cross recess screwdriver (for
unscrewing the electric kit) Slotted screwdriver
or size 10 socket wrench (for loosening the
hose).
1 Place a protective
cover onto the basin
and put the electric kit
with frontside down
onto the protective
cover.
2 Connect the hose
at the pump outlet and
then tighten the clamp
with a slotted screw-
driver or a size
10 wrench. Do not
tighten too strongly.
3 Place a protective
cover onto the floor and
put the electric kit with
onto it.
Attention!
Cable and hose are not
to be criss-cross.
4 Pull the cable from the
inside of the tank to the
back of the appliance.
In case the sealing
should not be visible,
please check that the
cable is not stuck some-
where in the electric kit.
5 Pull the hose and the
power cable and then
place the electric kit into
the inside of the tank.
6 After the electric kit
had been placed into
the tank, pull the cable
until the sealing comes
out at the cable and
gets clamped into the
slot at the stainless steel
plate.
7 Fix the electric kit with
4 self-drilling screws.
Attention!
Do not tighten the
screws too strongly
as they might get
damaged otherwise.