2 PREPARATION OF THE CLEANER
2.1 PREPARATION AND CONTROL
■
Take the parts washer out of the cardboard box packaging.
■
Control the parts washer in order to make sure that there is no damages.
■
The power supply cable has to be in good condition. The cable entry at the back plate has to be
properly mounted:
2.2 INSTALLATION
■
The filter sock has to fit closely to the housing body bottom.
■
To make sure that the filter out of stainless steel does not get caught on the filter sock, it has to be
rotated when inserting.
■
Put the drain cap onto the filter.By placing or taking off the lid the immersion area can be sealed or
opened.