Forch Powerwash Bio Mode D'emploi page 60

6.2 PARAMETER CHANGE
To change the parameters and before calling the configuration mode the heating hast o be switched
off (HEATING indicator light is off).
CALL
2,5 sec Call configuration mode:
Press the buttons BOOST and ECO for 2.5 seconds simultaneously.
The degreasing bath temperature and the duration of the ECO-mode are displayed.
As long as the configuration mode is active, "CHANGING" is displayed.
ECO
Change the duration of the ECO-mode:
For changing the duration of the ECO-mode press the buttons
Otherwise press the ON/OFF-button.
By pressing the ON/OFF-button the duration of the ECO-mode
is stored and the language used is displayed. By pressing the ON/OFF-button for
2 seconds you exit the configuration mode.
LANGUAGES
Change language:
By pressing the button
By pressing the ON/OFF-button the selected language is stored. "INCIDENTS"
is displayed.
(By pressing the ON/OFF-button for 2 seconds you exit the configuration mode).
INCIDENTS
Show incidents:
For displaying the stored incidents press the
stored, "NO INCIDENT" is displayed.
Otherwise the incidents are displayed which can be scrolled by pressing the
button.
TERMINATE
3 sec To terminate the change mode press the V-button for 3 seconds.
Without pressing that button the unit will return to normal operation mode after
60 seconds.
or the available languages are displayed.
and
button. If no incident had been