Description; Protections; Aerial Noise; Vibrations - Rancilio ROCKY Instructions Originales

2. DESCRIPTION

2.1 Features
The machine is composed of a single structure for
coffee grinding and dosage.
The machine has a cast aluminium structure with
plastic and stainless-steel panelling.
The coffee beans are held in a hopper fitted with a lid.
When the machine is turned on, the grinding device
under the hopper is activated. The ground coffee is
collected in the front container, from where the coffee
doses may by taken by activating a hand lever.

2.2 Protections

All moving parts are inside the machine panelling.
In the bean container 1 (Fig.3) a protection is fixed
with screws to protect your hands when filling and
cleaning the bean container.

2.3 Aerial noise

In working place the noise level does not generally
exceed 70dB(A).

2.4 Vibrations

The machine is supplied with rubber vibration sup-
pressing feet. In normal working conditions, the
machine does not produce vibrations harmful to the
operator and the environment.
2.5. Specifications and composition (Fig.3)
Legend:
1 Bean container
2 Main and coffee grinding switch
3 Grinding button (SD)
4 Grinding adjustment button
5 Filter support
6 Ground coffee exit chute (SD)
7 Ground coffee dose lever
8 Ground coffee container
9 Coffee binder
3. TECHNICAL DATA (Fig.4)
Machine dimensions
Packing dimensions
Packing volume
Net weight
Gross weight with
packing
No. of items
Grinder motor
Electricity supply
Bean container capacity
Gound coffe container
capacity
Working place tempe-
rature

4. USE

The machine has been designed to grind coffee.
Any other use is to be considered unsuitable and
therefore dangerous.
The user must always follow the indications contai-
ned in this manual. In the case of a failure or if the
machine is not working properly, switch it off and do
not attempt any direct repair.
Contact the assistance service.
The user must not:
● put his hands under the ground coffee container;
● transport the machine or carry out maintenance
operations with the plug connected and when the
machine is warm;
● pull the supply cable in order to disconnect the
machine from the supply network;
● use the machine if the supply cable is damaged;
● touch the machine with wet or damp hands or
feet;
● wash the machine with water or vapour jet;
● dip the machine in water or other liquid;
● use the machine when there are children in its
proximity;
● allow the machine to be used by children or inca-
pable person;
● obstruct the suction or heat despersal grilles with
cloths, ect.;
● leave the side doors open;
● place container with liquid on the machine
A=116 B =245
C=350mm.
A=230 B=340
C=410mm
0,03 m 3
7 kg
7,5 kg
1
1400W
See label data Fig.1
300 gr.
CA 200 gr.
+5° +45° C
29