Specified Conditions Of Use; User Groups; Care And Maintenance - Weller WXPP Traduction De La Notice Originale

EN
ENGLISH
Faults and defects must be repaired immediately.
Before using the unit / tool, safety devices must be carefully
checked to make sure that they are functioning properly and
in the manner intended. Check that moving parts are func-
tioning properly and are not sticking, and whether parts are
damaged. All parts must be correctly fitted and must satisfy
all the requirements necessary to guarantee troublefree
operation of the unit.
Use the correct tool. Use only accessories or auxiliary de-
vices which are included in the list of accessories or appro-
ved for use by the manufacturer. Use WELLER accessories
or auxiliary devices on original WELLER equipment only. The
use of other tools and other accessories can cause injury.
Secure the tool. Use clamping fixtures to hold the
workpiece.
Use a solder fume extraction unit. If appliances for
connecting solder fume extraction units are available, ensure
that they are connected and used properly.

Specified Conditions Of Use

Use the soldering iron exclusively for the purpose indicated
in the Operating Instructions of soldering and desoldering
under the conditions specified here.
The soldering iron may only used in combination with Weller
Supply Units.
This device may only be used at room temperature and
indoors. Protect against moisture and direct sunlight.

User groups

Due to differing degrees of risk and potential hazards, sever-
al work steps may only be performed by trained experts.
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Filter change
Operation
Filter change
Replacing electrical repla-
cement parts

Care and maintenance

WARNING
Before doing any work on the machine, pull the
plug out of the socket. Leave the unit to cool down.
12
User groups
Specialist personnel with
technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the
guidance and supervision of
a trained expert
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
Do not use blocked nozzles.
Repairs must always be referred to a
Weller-trained specialist.
Use original replacement parts only.
Risk of burns
WARNING
Only replace the soldering tips when they are cold.
•
The soldering tool must be left switched off in the safety rest
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF".
Temperature performance
The soldering tool has an internal usage sensor which can
be used to set an automatic switch-off function (Stand-by).
The settings can be found in the station's operating instruc-
tions.
Warranty
Claims by the buyer for physical defects are time-barred
after a period of one year from delivery to the buyer. This
does not apply to claims by the buyer for indemnification in
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has been
furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use
and if the device has been tampered with by unauthorised
persons.
For more information please visit
www.weller-tools.com.