22.1 Safety notices
Danger
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
22.2 Troubleshooting
The device does not work:
1. Check that the cable is properly plugged into the wall socket
2. Check cable for damage.
3. Verify that the wall socket works with another device.
22.3 Troubleshooting table
The digital display is lit, but the device does not start the cooking program and displays
an error code instead:
Error
Possible Causes
Code
E1
1. Cooking vessel is
empty
2. Water too low
3. Device is not
positioned correctly
on the table
4. Error in electronics
E4
The overheating
protection has been
triggered.
Danger
► If whole device or control element were in contact with water then unplug device and
contact customer service. Risk of electric shock!
► In the event of technical troubles, faulty devices or missing parts, please contact
Customer Service.
caso SV200
Solution
Fill clean water up to above the "MIN" level.
Fill clean water up to above the "MIN" level.
Place the device on a flat surface
Please contact customer service
When the water level is lower than MIN mark or the
water shortage sensor probably is not working
correctly, the overheating protection will be
activated. Pull the plug and let the device cool
down. Fill in enough water and plug in again.
PLEASE NOTE
39