Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
DW7231 D
WALT Miter Saw Mounting
E
Method (Fig. 2, 3)
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling
the miter saw to the miter saw stand. An accidental start-up can
cause injury.
WARNING: Stability Hazard. You must use the Universal
Miter Saw Mounting Method when mounting a miter saw not
manufactured by D
WALT to this miter saw stand.
E
WARNING: To reduce the risk of personal injury, be sure the miter
saw is fully anchored on the stand.
WARNING: For your own safety, read and understand the miter saw
instruction manual before using. Failure to heed these warnings may
result in personal injury and serious damage to the miter saw and the
accessory.
1. Place saw in operational position with blade facing you. Align with
label on the mounting bracket showing front.
2. Place a spacer, such as a 2 x 4, under one side of the miter saw
to hold the saw's mounting feet above the work surface.
3. Hold a mounting bracket under the saw and feed a carriage bolt
(hardware bag) up through the bracket and the foot of the saw.
NOTE: See DW7231 Hardware Selection Chart for the correct
mounting hardware procedures for D
instructions properly, otherwise the miter saw's table rotation may
be obstructed.
WALT miter saws. Follow all
E
2
DW7231 HARDWARE SELECTION CHART
Left Side
DW703
DW705
DW706
DW708
DW712
DW713
DW715
DW716
DW717
DW718
DWS780
1 = Long screw, Head on bottom
2 = Short screw, Head on bottom
3 = Long screw, Head on top
4. Once the carriage bolt (hardware bag) is installed per DW7231
Hardware Selection Chart, assemble a flat washer, lock washer
and nut onto the bolt. Tighten the bolts finger tight.
Right Side
1
1
1
1
1
1
1
2
1
2
1
1
1
1
1
1
2
1
3
2
3
2
Publicité
Table des Matières
