Heat Mode - GE AJCM 08 ACD Série Manuel D'utilisation Et Instructions D'installation

COOL MODE
Remote Control
1. Press COOL pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the INCREASE + / DECREASE – pads to set the
desired temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the COOL indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light
is lit for desired fan speed.
3. Press the INCREASE + / DECREASE – pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler.

HEAT MODE

Remote Control
1. Press HEAT pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the INCREASE + / DECREASE – pads to set the
desired temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the HEAT indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light
is lit for desired fan speed.
3. Press the INCREASE + / DECREASE – pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a higher
number and the indoor air will become warmer.
FAN
Use the FAN to provide air circulation and filtering without
cooling or heating. Since fan only settings do not provide
cooling or heating, a temperature setting will not be
displayed.
Set the thermostat at a higher number and the indoor air
will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and HIGH
fan with a middle set temperature.
For Maximum Cooling—Select the COOL mode
and HIGH fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the COOL
mode and LOW fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting
changes such as COOL to OFF and back to COOL.
Set the thermostat at a lower number and the indoor air
will become cooler.
NOTE: If the air conditioner is off and is then turned on
while set to HEAT, it will take approximately 3 minutes
for the compressor to start and heating to begin.
Heating Descriptions
For Normal Heating—Select the Heat mode and HIGH
fan with a middle set temperature.
For Maximum Heating—Select the HEAT mode
and HIGH fan with a higher set temperature.
For Quieter and Nighttime Heating—Select the HEAT
mode and LOW fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting
changes such as HEAT to OFF and back to HEAT.
Remote Control
Press FAN pad. Press LOW or HIGH pads to set desired
fan speed.
Control Panel
Press the MODE pad until the FAN indicator light is lit
and the LOW or HIGH indicator light is lit for the desired
fan speed.
GEAppliances.com
7