Cool Mode; Fan Mode - GE AJCM 08 ACD Série Manuel D'utilisation Et Instructions D'installation

COOL MODE

Remote Control
1. Press COOL pad.
2. Press LOW, MED or HIGH pads to set desired fan
speed.
3. Press the INCREASE + / DECREASE – pads to set
the desired temperature 60°F to 85°F in 1°F
increments.
Control Panel
1. Press the MODE pad until the COOL indicator light is lit
and the LOW, MED or HIGH indicator light is lit for the
desired fan speed.
2. Press the INCREASE + / DECREASE – pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler.

FAN MODE

Use the FAN mode to provide air circulation and filtering
without cooling. Since fan-only settings do not provide
cooling, a temperature setting will not be displayed.
Set the thermostat at a higher number and the indoor air
will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and HIGH
or MED fan with a middle set temperature.
For Maximum Cooling—Select the COOL mode
and HIGH fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the COOL
mode and LOW fan with a middle set temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a COOL setting.
Remote Control
Press FAN pad. Press LOW, MED or HIGH pads to set
desired fan speed.
Control Panel
Press the MODE pad until the FAN indicator light is lit
and the LOW, MED or HIGH indicator light is lit for the
desired fan speed.
GEAppliances.com
5