Installing A J-Model In An Existing Wall Case - GE AJCM 08 ACD Série Manuel D'utilisation Et Instructions D'installation

INSTALLING A J-MODEL IN AN EXISTING WALL CASE

Read these instructions completely and carefully.
REMOVE LOCKING PLATE ON FRONT
1
LEFT SIDE
Locking
plate
Remove
screw
REMOVE ALL SHIPPING PADS
2
(IF PRESENT) INSIDE AIR CONDITIONER
NEXT TO COMPRESSOR
CAREFULLY SLIDE AIR CONDITIONER
3
BACK INTO CASE
Make sure that the tubing on the unit does
not touch the wall case and that the case
installation is secure.
Installation Instructions
Remove
shipping
pads (if
present)
14
REINSTALL LOCKING PLATE WITH TAB
4
BEHIND WALL CASE FLANGE. TIGHTEN
SCREW
ATTACH POWER CORD TO BASE PAN
5
WITH CLAMP
ATTACH FRONT GRILLE
6
An opening for the power cord is on the bottom
of the front grille.
Base pan
Power cord
Clamp