Panasonic WV-Q119 Manuel D'utilisation page 7

Step 4
Attach the camera mount bracket supplied with
the camera to the upper case.
Mount the camera mount bracket with the sup-
plied screws (M4 x L4) in the consideration of
the bracket direction as shown in the drawing
below.
Recommended tightening torque:
1.56 N·m {1.16 lbf·ft}
Step 5
Attach the upper case and the bracket to the
wall and run the cables.
Attach it with four screws. Screws are not pro-
vided.
Prepare them in accordance with the camera
installation position.
• Necessary screw:
• Minimum pull-out strength:
Screws
(M4, to be separately purchased)
Upper case
Chassis
Camera mount bracket
Screws
(M4 x L4, for securing
camera mount bracket
supplied with the camera)
M4 (4 pcs.)
196 N {44 lbf}
Step 6
Attach the safety wire locked on the camera
mount bracket to the camera body.
Ensure that the safety wire is steadily engaged
with the hook of the camera body.
* The upper case and chassis are not
described in the illustration below.
Step 7
Connect the cables to the external I/O termi-
nals, microphone/line connector, audio output
connector, and monitor output connector.
Refer to the operating instructions of the cam-
era for descriptions of connections. Hold the
camera body securely at connections.
Step 8
Connect the cables to the network terminal
and 12 V DC power supply terminal.
Refer to the operating instructions of the cam-
era body for descriptions of connections.
Safety wire
Safety wire holder
7