System Information - afx light BEAM1R-MKII Manuel D'utilisation

X Reverse
Y Reverse
X/Y Exchange
No DMX Signal
Display screen
protect
Lamp on start up
Restore to default
set
2.3. Manual control interface
This interface uses for control present light, and then auto enter into master mode (didn't receive
DMX signal, sent the dmx signal to slave light)
Manual menu will according to standard 12Channel to set menu (Dimmer and strobe not used)
Option Instruction
1CH. X 0~255
...... 0~255
12CH. Macro 0~255
function
13CH. Reset

2.4 System information

Option
Software version
DMX Channel
System error record
Note: Sometimes it not
the installation problem
of Hall or optocoupler. It is
because the motor cable
inversely connect
Total using hour
This time using hour
Total lighting hour
EN 6
OFF
ON
OFF
ON
OFF
ON Change the channel of X/Y axis (include X/Y Fine)
KEEP According to the original state continues to run
CLEAR Motor reset, stop running
ON Closing backlight after free 30seconds
OFF Backlight still lighting
OFF Reset directly after Power on, lamp off (need to use the
menu or control table to manual let lamp light)
ON Lamp light directly after power on, And must wait for the
lamp light up success then reset
Press ok key see the confirmation dialog box, Press OK key
to restore to default set
Press OK key into edit state, Then selected hundreds place. Press
up or down, change address code. Press OK key again, selected ten
place and edit. Press OK key again, select the first place and edit.
Press it to exit the edit state.
Press ok key see the confirmation dialog box, Press OK key to reset
surface, all motors reset
Instruction
Current software version
Enter into sub-surface, using value and percentage show the DMX
channel to check
If the red ERR indicator light light on, it means fixture running error,
and enter the sub-surface to check the details. Press "Clear" to emp-
ty the error record after finish check
Total using hour (accurate to minute)
The using hour from the power on (accurate to minute)
Total lighting hour (accurate to minute)
© Copyright LOTRONIC 2020