Advanced Setup - afx light BEAM1R-MKII Manuel D'utilisation

OPERATION
2.1 Press "MODE" to switch the menu
• SET setup
o Run mode : Choose operating mode ( AUTO / SOUND / DMX / SLAVE )
o DMX address : Set DMX address
o Channel mode
o Lamp control
o Sound sensitive
o X reverse
o Y reverse
o X/Y exchange
o No DMX signal
o Screen protect
o Open the lamp
o Restore to default settings
• MENU setup ( manual control of each DMX channel )
• SYSTEM setup
o Software version
o DMX monitor : To see DMX information
o System errors : To see fixture errors
o Total fixture hours : To see used time of fixture
o Partial fixture hours
o Total lamp hours : To see used time of lamp
o Partial lamp hours

• ADVANCED setup

o Sensor monitor
o Reset calibration
o Lamp life hours : to see life time of the lamp
o Lamps hours clear
• Chinese – English switch
• Display screen reverse
2.2 Set up the interface
Option Instruction
Run Mode
DMX Address
Channel Mode
DMX Slave state:Accept control table or main engine
Auto1 Master State: Auto running and send DMX signal for Slave
Auto2
Random auto
Sound control
1-512 Press OK to edit. Selected the digit of hundreds. Press up or
down to change address code. Press OK again. Select the di-
git of tens and edit. Press OK again, select the digit of units
and edit. Press it to exit the edit state.
12 12CH Mode
www.afx-light.com
5 EN