Installation And Connection - Oase InScenio FM-Master EGC Notice D'emploi

- EN -
Product Description
Function description
InScenio FM-Master EGC is a device control system with a wireless local area network (WIFI). The connected devices
can be controlled via a smartphone or tablet and the "OASE Easy Control" app.
Features:
• Four sockets that can be switched, one of which has a dimmer function.
• 24 hour control of each socket by means of an integrated timer.
• Up to 10 OASE units with hand-held transmitters can be additionally integrated and controlled via the app.
• Control possibilities for EGC-compatible end devices.
– The Easy Garden Control System (EGC) allows convenient control of units in the garden and pond, and ensures
maximum convenience and reliability.
– Information about EGC and the possibilities it offers can be found at www.oase-livingwater.com/egc-start.
• The InScenio FM-Master EGC Cloud allows EGC-compatible end devices to be controlled from anywhere via the
OASE web portal. The web portal can be accessed at https://egccloud.oase-livingwater.com.
• Cover to protect against splash water allows the unit to be used throughout the year.
Intended use
InScenio FM-Master EGC, referred to as "unit", may only be used as specified in the following:
• Operation only as a power supply distributor for suitable OASE products.
• Operation only at ambient temperatures of -20 °C ... +45 °C.
• Operate in accordance with instructions.

Installation and connection

A T T E N T I O N ! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Only operate the unit with the protection hood fitted.
• Ensure that the unit is installed in a flood protected position at a distance of at least 2 m from the water.
Connecting the antenna
How to proceed:
 C
1. Remove the blind plug and screw the antenna into place.
2. Align the antenna.
Installing the unit
How to proceed:
 B
• Install the unit at least 2 m from the edge of the pond.
 D
1. Remove the protection hood from the unit.
2. Insert the ground stake by approx. ¾ of its length into the ground.
3. Slide the device onto the ground stake.
4. With the unit, push the ground stake fully into the ground.
5. Check its stability.
14