Oase LunAqua Maxi LED Set 1 Notice D'emploi page 12

- EN -
Commissioning/start-up
N O T E
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
A T T E N T I O N ! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Note:
The LED light cannot be dimmed. The brightness of an LED reduces as the operating time increases.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
Changing the lens (G)
A T T E N T I O N ! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Each lamp is fitted with a 30° lens. The lens can be replaced by a 10° lens (part of the scope of delivery).
How to proceed:
• Hold the lamp at its foot (15). Do not hold at the end cap (16), as it would unscrew.
• Hold the front cap (19) using a leather or textile cloth (to enhance the grip!) and unscrew counter-clockwise.
• Slightly tap to remove the protection disk (18) and the lens (17) from the lamp.
• Replace the lens, then reassemble the unit in the reverse order.
12