Product Description - Oase StreamMax Pump Controller Notice D'emploi

PRODUCT DESCRIPTION

Max. two StreamMax Premium flow pumps can be
connected to the StreamMax Pump Controller. The
unit controls the speed of the connected flow pumps.
The EAC Aquarium Controller is used to integrate the
StreamMax Pump Controller into the Easy Aquarium
Control-System (EAC).
Easy Aquarium Control System (EAC)
This product can communicate with the Easy Aquari-
um Control-System (EAC). EAC allows convenient
control via smartphone or tablet, and ensures maxi-
mum convenience and reliability. For information on
EAC and the possibilities it offers, visit:
livingwater.com/eac-start
Unit layout and scope of delivery
5 A StreamMax Pump Controller
1 StreamMax Pump Controller
2 Power pack
3 Power cable
4 Data cable , for connecting the StreamMax Pump
Controller to the EAC Aquarium Controller
Intended use
StreamMax Pump Controller, referred to as "unit",
may only be used as specified in the following:
· For controlling StreamMax Premium pumps.
· Operate in accordance
(→ Technical data)
· Only operate with the original power pack.
· Only use indoors and for aquaristic purposes in the
home (not for commercial use).
Accessories
· StreamMax Premium flow pump 2000 (33948) /
4000 (33949) / 5000 (33955).
· EAC Aquarium Controller (33885).
www.oase-
with instructions.
CONNECTION
5 B, C
· P1/P2: Insert the plugs of the flow pump into the
socket on the StreamMax Pump Controller.
– Route the connecting line with a loop, so that
dripping water cannot enter the socket.
· Power: Insert the plugs of the power pack into the
socket on the StreamMax Pump Controller.
– Push hard until the plug locks in place.
· EAC: Connect StreamMax Pump Controller and EAC
Aquarium Controller with the data cable (optional).
– Ensure that the lug of the RJ-45 plug locks in
place.
COMMISSIONING/START-UP
Proceed as follows for initial start-up:
3. Switch on StreamMax
(→ Switching the unit on/off)
4. Configure the connected flow pumps, so that they
can be controlled. (→ Configuring connections P1
and P2)
5. Configure the flow pumps for the "Feeding" mode.
(→ Configuring the "feeding" mode)
6. Activate the desired speed control mode.
(→ Operating mode and configuration mode)
Switching the unit on/off
· Switching on: Connect the unit to the mains. The
unit switches on immediately.
· Switching off: Disconnect the unit from the mains.
OPERATION
Display and keys
· The display flashes for approx. 10 s after confir-
mation of a speed or a flow profile.
· After approx. 40 s without any operating actions,
the display will be switched off.
- The dot signals that the unit is operating.
- Press any key to switch the display on again.
To previous level
Scroll forward, increase value
Scroll backward, decrease value
· Change to the input level.
· Confirm selection or value.
- Values are applied immediately.
· Activate feeding mode: Press and hod the button
for approx. 3 s.
- EN -
Pump Controller.
11