Preparation And Set Up - Neato botvac D3 connected Guide De L'utilisateur

Preparation and Set Up

1 REMOVE FILMS AND STICKERS
IMPORTANT
Remove all protective films and shipping
material from the robot and charge base.
If they are not removed, your Neato robot
will not operate correctly.
2 SET UP CHARGE BASE
Plug the power cord securely into the
charge base.
Adjust the length of the cord by wrapping
it as shown.
6
Choose a wall outlet that has a 3' (1 m)
clearance on both sides and in front of the
charge base. This helps your robot find the
charge base.
Plug in the power cord and push the charge
base against the wall.
TIP Locate the charge base on a hard floor
surface.
TIP Make sure the power outlet is not
controlled by a switch.
3 INITIAL ROBOT CHARGING
Place the rounded side of your Neato robot
against the metal charging contacts on the
charge base until the contacts are pushed
all of the way in. For best results, charge the
robot fully before your first cleaning cycle to
experience a full high performance cleaning.
Charging
Contacts
NOTE During bootup, the robot will
alternately blink green and blue.
NOTE Your robot is only compatible with the
included charge base.