Velleman AVM360 Notice D'emploi page 4

• Handle the multimeter gently and carefully. Dropping it can damage the circuit boards and case and can cause
the multimeter to work improperly.
• Use only fresh batteries of the required size and type. Always remove old or weak batteries.
If you do not plan to use the multimeter for a month or more, remove the batteries. This protects the multimeter
from possible leakage.
• Disconnect the test probes before opening the multimeter.
• Replace blown fuse only with same size and type :
F 1.5A / 250V
• If any faults or abnormalities are observed, do not use this device and let it check by authorised personnel.
• Never use the meter unless the back cover is in place and fastened fully.
• To clean the meter, use a damp cloth and mild detergent only, do not use abrasives or solvents.
2. Description of the meter
Indicator zero corrector
Range selector switch knob
Measuring terminal +
Measuring terminal - COM (common)
DC 10A terminal
0 Ω adjusting knob
Panel
Indicator Pointer
Rear case bolt
Rear case
3. Reference table for reading
AVM360 4 VELLEMAN