Environmental Protection - Ryobi RCD1201 Traduction Des Instructions Originales

mask with filters suitable for protecting against
particles from the material being worked on.
RISK REDUCTION
It has been reported that vibrations from hand-held tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
Keep your body warm in cold weather. When operating
the unit wear gloves to keep the hands and wrists
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 81.
1. Keyless chuck
2.
3. LED Indicator (Fuel gauge)
4.
5. Switch trigger
6. Battery port
7. Handle, insulated gripping surface
MAINTENANCE
When servicing, use only identical RYOBI replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
2

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
LED INDICATOR
Battery charge
66% - 100%
33% - 66%
< 33%
NOTE: If only the red LED indicator is illuminated, it
means the battery power is low. The battery needs to be
recharged.
BATTERY OVERLOAD PROTECTION
This tool is designed to protect the battery from overloading.
When overloading is detected, the tool will automatically
switch off. To resume operation, switch the tool off and
on again. If the tool fails to operate, it means battery pack
is discharged and should be recharged in a compatible
charger.
SYMBOL
Safety alert
No-load speed
V Volts
Direct current
min -1 Revolutions or reciprocations per minute
Chuck capacity
EurAsian Conformity Mark
CE conformity
Ukrainian mark of conformity
English
LED colour
Green + Yellow + Red
Yellow + Red
Red