Before Initial Use; Toasting - DS Produkte TA1046-GS Mode D'emploi

Before Initial Use

PLEASE NOTE!
■ There may still be some production residues on the device. To avoid harmful effects
to your health, thoroughly clean the device before you use it for the fi rst time.
1. Remove any fi lms or stickers that may be present from the device.
2. Check whether the lowering lever can be operated smoothly.
3. Unwind the cable from the cable winder to the length you require.
4. Place the toaster on a dry, heat-resistant, fl at surface a suffi cient distance away from
fl ammable objects.
5. The mains plug should be connected to a socket that has been properly installed.
6. Perform 3 toasting operations at the highest level without bread in order to remove
any production residues. Ensure that there is an interval of a few minutes between
the toasting operations.

Toasting

The extent of browning depends greatly on the type, the freshness and the composition
of the bread which is used. An increased protein, sugar or calcium content, for example,
leads to stronger browning, whereas fats and preservatives reduce it.
Initially, depending on your own personal taste and the bread, you should start with a low
toasting setting and increase it in stages until you get an optimum level of browning that
you are happy with.
PLEASE NOTE!
■ Before using the device, make sure the crumb tray is inserted completely.
■ Make sure that the toaster can switch off after the toasting process. Problems may
be caused by objects that block the lowering lever, or by baking products which are
too large in the toasting slots.
1. Insert a slice of bread into each of the toasting slots (2). Do not use slices which are
too thick, because they could get stuck in the toasting slots (2).
2. Use the rotary knob (7) to set the desired toasting setting between level 1 (light toasting; very
light degree of browning) and stage 7 (strong toasting; very strong degree of browning).
Please note: If you use the device over a prolonged period, the slices which are
put into the device later on will be darker than the fi rst slices at the same toasting
setting.
3. Press the lowering lever (3) down until it engages. (The lowering lever (3) only clicks
into place if the device is connected to a power socket.) The device is switched on,
the toasting process starts and the Stop key (6) lights up.
4. After the end of the toasting process, the bread and the lowering lever (3) are
automatically raised and the device switches itself off. The Stop key (6) switches off.
5. Remove the bread carefully from the toasting slots (2).
6. If you have fi nished using the device you pull the mains plug out of the socket and
allow the device to cool down.
15 EN