Power Supply - Monacor security TVCCD-1602COL Mode D'emploi

When controlling the camera via RS-485 data transmis-
GB
sion, connect pin 1 [TxD (A)] and pin 2 [RxD (B)] via a
twisted pair to the computer / control console. For connec-
tion, the camera is supplied with a matching 6-pole plug.
When controlling a single camera, set the switch "TERMI-
NATION" (7) to "ON"; when controlling several cameras,
only set the switch on the last camera to "ON", the switch
on the other cameras to "OFF". For further information
concerning the RS-485 interface please contact the
MONACOR after-sales service.
5.3 External zoom/focus control
Zoom and focus settings can also be made via an exter-
nal control unit supplying a control voltage between 6 V
and 12 V for motor zoom lenses. Connect the control
unit via the supplied 3-core cable to the 3-pole tip jack (6):
pin "Z" (white core): input for zoom control
A positive control voltage corresponds to the function of
zoom button "T" (tele), a negative control voltage cor-
responds to the function of zoom button "W" (wide
angle).
pin "F" (yellow core): input for focus control
A positive control voltage corresponds to the function of
16
focus button "N" (near), a negative control voltage cor-
responds to the function of focus button "F" (far).
pin "C": ground (black core)
Note: For recalling the first page of the OSD menu to
check the menu settings, simultaneously feed a negative
control voltage to pins "Z" and "F". The menu page will be
displayed as long as the control voltage is applied to both
pins.

5.4 Power supply

For power supply, connect a regulated power supply unit
(e. g. MONACOR PS-1615ST) with an output voltage of
12 V and a current rating of 500 mA to the two screw ter-
minals "+12V" and "GND" (9). Observe the correct polarity.
6 Operation
Remove the lens cover and connect the camera to the
power supply. The red LED "POWER" (4) will light up and
the monitor will display "LENS INITIAL" first, then the
camera picture.
Via the OSD menu, the functions of the camera can be
matched to the corresponding application, see chapter 7.