How To Run A Wash Cycle; Using For The First Time; Daily Use - Zanussi ZWK 5120 Notice D'utilisation

How to run a wash cycle ?

Using for the first time

IMPORTANT !
• Ensure the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene insert and all other
items inside the drum.
• Run an initial wash cycle at 90°C, without any
washing but with detergent to clean the water
tank.

Daily use

Loading washing
• Open the lid of the appliance.
• Open the drum by depressing the locking but-
ton A : The two shutters unlock automatically.
• Load the washing, close the drum and the lid
of your washing machine.
A
WARNING !
Before closing the lid of your appliance, ensure
that the drum is properly closed :
• When the two shutters are closed,
• locking button A released.
34
Proportioning of detergents
Your washing machine has been designed to
reduce your water and detergent consumption.
You can therefore reduce the amounts recom-
mended by detergent manufacturers.
Pour the amount of washing powder into the
washing and prewash
you have selected the "prewash" option. Pour
fabric softener into the compartment if neces-
sary .
If you use another detergent type, refer to the
section "detergents and additives" in the
washing guide.
Selection of desired programme
You can find the right programme for different
types of washing in the programme table (see
"Programme table").
Turn the programme selector to the required
programme. The "Start/Pause" pushbutton
flashes green.
WARNING !
If you turn the programme selector to another
programme while a cycle is in progress, the
appliance will ignore the new selected pro-
gramme. The «Start/Pause» pushbutton flashes
red for a few seconds.
compartments if