Setting The Transmission Frequency; Remoset Function; Identification Number - JTS MONACOR INTERNATIONAL R-4TBM/5 Mode D'emploi

Light Time
15 Sec.
= no backlight
Always OFF
– = time in seconds
5 30 Sec.
= backlight always on
Always ON
Hint: To save the batteries, it is advisable not to use
as a permanent setting
Always ON
3) For a reset to the factory settings, select the
menu item
Reset
A message appears to warn you that reset-
ting will erase any data stored:
All stored
data will be
erased.
Yes / No
Fig. 6
To cancel the process, retain the option
and press the button SET; to reset, use the
button  to select
ton SET

3.7 Setting the transmission frequency

Before switching on the pocket transmitter, set
the receiver to an interference-free frequency
(refer to the instruction manual of the receiver)
Then set the transmitter to the same frequency
There are three methods to do this:
1 If you operate the pocket transmitter together
with the receiver R-4 / 5, the easiest way is to
use the patented REMOSET function When
you press the button REMOSET on the re-
ceiver, the transmitter is set to the trans-
mission frequency selected on the receiver
(chapter 3 7 1)
2 The transmission frequency can be ad-
justed manually between 506 000 MHz and
542 000 MHz (chapter 3 7 2)
3 For operating multiple audio transmission sys-
tems at the same time, there are 6 groups
with up to 22 channels in each group (refer
to the table on page 35) In ideal condi-
tions, all channels from a group can be used
for audio transmission at the same time If
the receiver has been set to a channel from
these groups, select the same channel for the
pocket transmitter (chapter 3 7 3)
Fig. 5
and press the button SET
and press the but-
Yes

3.7.1 REMOSET function

For the REMOSET function always make sure
that
1 no menu is called up on the pocket transmit-
ter or on the receiver
2 the transmitter is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the transmitter and the receiver are set to
the same identification number (ID No ) or
that the function ID No is deactivated (see
paragraph "Identification number")
4 the REMOSET function is not disabled (see
paragraph "Disabling the REMOSET func-
tion")
– Identification number –
To prevent mutual interference of individual
No
pairs of transmitter / receiver during REMOSET
transmission, each pair must have a different
identification number (ID No ) If you only use
one pair of transmitter / receiver, there is no need
to change the preset ID No 1 To change the
ID No :
1) Call up the setting for the ID No via the
menu item
Remoset ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button
 to deactivate the function (OFF) or the
button  to activate the function (ON) If the
function has been deactivated, the REMOSET
transmission will be possible from any R-4 / 5
receiver; if the function has been activated,
the REMOSET transmission will only be pos-
sible from a receiver with the same ID No
4) Press the button SET to save the setting
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the pocket transmitter has been set to
the transmission frequency or to the group and
the transmission channel of the receiver, the LED
REMOSET (3) shows blue for five seconds and
the display indicates
of the main menu
Remoset ID
Fig. 7
Sync...
15