Main Modes; Advanced Setting - Sharp SJ-WX830F Mode D'emploi

Main modes

Controlling temperature
• The refrigerator controls its temperature automatically.
You can set the preset temperature as below.
• See "Multi temperature room" about the preset
temperature of multi temperature room.
Refrigerator
• Default setting is 3°C.
• You can adjust between 0°C and 6°C in step of 1°C.
Procedure
1
Press enter key.
2
Select the
compartment.
The compartments change in the order shown as
on the picture by pressing this key.
→
3
Decrease Increase
Decrease Increase
Set the temperature.
4
Press enter key.
Freezer
• Default setting is -18°C.
• You can adjust between -13°C and -21°C in step of 1°C.
Procedure
1
Press enter key.
2
Select the
compartment.
The compartments change in the order shown as
on the picture by pressing this key.
→
EN-8
Display
Current setting
→ →
Display
Current setting
→ →
3
Decrease Increase
Decrease Increase
or
or
Set the temperature.
4
Press enter key.

Advanced setting

• You can adjust the temperature in steps of 0.5°C in the
following way at procedure 3.
E.g. Refrigerator
Procedure
3
Decrease Increase
Increase
Decrease
Set the temperature.
Set the
temperature
again.
Note
• The temperature that indicated on the control panel
is not the exact temperature inside.
• The internal temperatures could be affected by such
factors as the location of the refrigerator, ambient
temperature and the frequency of door opening.
Temperature rise sign
If the inside temperature becomes as follows, this sign
lights up.
Refrigerator : more than 10°C
Freezer : more than -10°C
• Check the quality of food before you eat.
• This sign may light up at start of power supply.
This sign turns off by opening or closing the door of
lighted compartment of compartment select key when
this sign is ON.
Display