Vacation Mode; Tips For Saving Energy - Sharp SJ-WX830F Mode D'emploi

Main modes
Energy saving
• Use this mode to switch the appliance to energy-saving
operation.
How to operate
Procedure
1
Press enter key.
2
Press icon.
3
Press icon again.
• ON / OFF switches in the order by pressing the icon.
4
Press enter key.
• While this mode is operating, the temperature inside
of the refrigerator and freezer compartment becomes
higher than the normal operation as follows. The
displayed temperature is not be changed.
Under "Energy
saving" mode
Approx. 2°C plus
(When the temperature is set at F: -18°C, R: 3°C.)
• Cancel this mode if you feel the beverages are not
cooled enough or ice making takes longer time.
Note
• The efficiency of power saving depends on the
usage environment (controlling temperature, ambient
temperature, frequency of opening the doors, amount of
food).

Tips for saving energy

• Install the refrigerator in a well-ventilated area and keep
the space to ventilate.
• Keep your refrigerator out of direct sunlight and do not
place it next to heat generating appliance.
• Avoid opening the door as much as possible.
• Hot food should be cooled before storing.
• Place the food evenly on the shelves to allow the cool
air to circulate efficiently.
Display
Current setting
(This indication shows OFF.)
The setting is changed.
Freezer Refrigerator
Approx. 1°C plus

Vacation mode

• Use this mode when going on a trip or leaving the house
for a long time.
• The temperature inside the refrigerator compartment is
adjusted to approx. 10°C.
How to operate
Procedure
1
Press enter key.
2
Press icon.
3
Press icon again.
• ON / OFF switches in the order by pressing the icon.
4
Press enter key.
Note
• Food storage period in the refrigerator compartment
becomes approx. 1/2-1/3 of normal operation.
Use this mode only when there is no perishable food.
• Temperature of refrigerator compartment cannot be
modified. ("10°C" is indicated on the display.)
• The amount of energy consumption of this model is
measured as shown in the picture below.
90mm
300mm 300mm
Display
Current setting
(This indication shows OFF.)
The setting is changed.
< Standby display >
50mm
EN-9
EN