Making An Audio Recording; To Set For Automatic Standby Status (Auto Power Down); Restoring All The Settings To The Factory Default Settings - Pioneer A-10-K Mode D'emploi

Operation

Making an audio recording

You can make an audio recording from any audio source connected to the amplifier.
SACD/CD player
Network audio player
/I STANDBY/ON
STANDBY PURE AUDIO Hi-Bit 32
iPod/USB
5V 2.1A
Audio recording component
(CD recorder, tape deck, etc.)
1 Select the source you want to record.
SACD/CD NETWORK PHONO
TUNER AUX
2 Start recording, then start playback of
the source component.
iPod dock, etc
Turntable
iPod
Music>
Extras>
Settings>
Shuffle Songs
Backlight
Tuner
MENU
N-50
NETWORK AUDIO PLAYER  
FUNCTION 
  
Playback
1
Recording

To set for automatic standby status (Auto Power Down)

When this condition is set, if no input signal is detected for 30 minutes, the unit will automatically enter standby
status.
1 If the unit's power is ON, hold the unit's front-panel DIRECT button and LOUDNESS
button depressed simultaneously for three seconds.
When this condition is set to ON, the STANDBY/APD indicator on the unit's front panel will light green. Press the
buttons again to disable the setting.
• This condition can also be set by means of the APD button on the A-30's remote control.
• The factory default setting is ON.
Note
• Depending on the device connected, excessive noise produced by the device may be interpreted as an audio
signal, thus preventing the Automatic Power-Down function from operating.

Restoring all the settings to the factory default settings

1 When power is in standby mode, hold the front-panel's DIRECT button and
SPEAKERS A button depressed simultaneously for five seconds.
2 Turn power ON to the unit.
04
11
En