Scan Function; Identification Number; Lock Function - Monacor International JTS IN-164R /2 Mode D'emploi

sion (brief insertion
it is, this channel already used will be skipped.
5) Press the button SET to confirm. The display
briefly shows
return to the normal mode.

5.1.2 Scan function

The scan function makes it easier to select a free
transmission frequency: When the function has
been activated, the frequencies already being used
for transmission will be skipped when you set the
transmission frequency (
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group set-
ting mode is activated.
2) Press the button SET repeatedly until the dis-
play shows the current setting for the scan func-
tion:
scan function activated
scan function deactivated
3) Press the button
or the button
.
4) Press the button SET to confirm. The display
briefly shows
the normal mode.

5.1.3 Identification number

To set the transmitter to the transmission fre -
quency of the receiver via the REMOSET function
( chapter 5.2), both must have the same identi-
fication number.
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group set-
ting mode is activated.
2) Press the button SET repeatedly until the dis-
play shows
number ( ...
3) Select the desired number with the button
or the button
4) Press the button SET to confirm. The display
briefly shows
the normal mode.
5) Then set the identification number on the trans-
mitter instruction manual of the transmitter.
12
= "scan channel"). If
(= store). The receiver will
chapter 5.1.1).
(5) to select the setting
(7) to select the setting
. The receiver will return to
and the current identification
).
(7).
. The receiver will return to

5.1.4 Lock function

When the lock function has been activated, the
REMOSET function will not be available (
ter 5.2) and it will not be possible to switch off the
receiver. From the setting modes, you will only be
able to activate the mode for the lock function in
order to deactivate the lock.
Activating the lock
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group set-
ting mode is activated.
2) Press the button SET repeatedly until the dis-
play shows
flashing.
3) To activate the lock, press the button
display shows
4) Press the button SET to confirm. The display
briefly shows
the normal mode.
The indication LOCK (e) on the display
shows that the lock has been activated. When
you press a button or when you set the on/off
switch (8) to OFF,
Deactivating the lock
1) Make sure that the on/off switch (8) is set to ON.
2) Keep the button SET (6) pressed until the indi-
cation LOCK (e) starts flashing on the display.
3) To deactivate the lock, press the button
The display shows
4) Press the button SET to confirm. The display
briefly shows
normal mode.
(5)
(lock off) and LOCK (e) starts
(7). The
.
. The receiver will return to
appears in addition.
.
. The unit will return to the
chap-
(5).