Mounting The Service Door - Dometic SK4 Instructions De Montage Et De Service

Mounting the service door

5 Mounting the service door
I
NOTE
Observe the following supplements.
➤ Mount the service door as shown in the figures: fig. 3 to fig. f.
Supplementary to fig. 3
The service door can be installed horizontally and vertically. If mounted vertically, the
hinges must point in the driving direction.
Supplementary to fig. 4
➤ Disassemble the trim and other attachments at the installation site of the service
door.
Supplementary to fig. 5
➤ Prior to cutting the opening, the outer frame must extend about 20 mm beyond
the opening and the clamping frame about 15 mm.
The exact dimensions are shown in the "Dimensions" table on page 4 and
fig. 1.
I
NOTE
You need the cut-out part of the wall as filling for the door.
Supplementary to fig. 6
➤ When cutting the door filling, ensure that with any existing trim there is no offset
from the wall.
Supplementary to fig. 7
➤ For wall thicknesses of less than 33 mm (
Shorten the clamping frame circumferentially by 10 mm in each case.
6
, ,
SK4
:
)
EN