Adjusting The Auto White Balance - JVC TK-C9510E Manuel D'instructions

Adjusting the Auto White Balance

Each light source has its own colour temperature. Therefore, when the
main light source illuminating the subject is changed, adjust the white
balance again. Perform white balance adjustment for each scene file.
1 Press the [MENU] button.
2 Select the scene file for which white balance is to be adjusted.
Select [SCENE FILE], and move the cross key to the left/right to select
a scene file.
3 Move the cross key up/down to select [BASIC SETTINGS].
The [BASIC SETTINGS] screen appears.
4 Move the cross key up/down to select [WHITE BALANCE].
5 Move the cross key to the left/right to select "AWC", and press
the [SET] button.
The [W.BAL CONTROL] screen appears.
6 Zoom in to fill the screen with white.
Place a white object at the center of the screen under the same lighting
condition as the subject to be shot, and zoom in to fill the screen with
white.
7 Select the [AWC SET] item, and press the [SET] button.
Auto white balance adjustment begins. During operation, "AWC
OPERATION" is displayed on the screen.
When the appropriate white balance is achieved, "AWC OK" is
displayed, and adjustment is complete.
"Error Message" (A page 69)
Memo Perform white balance adjustment on each scene file as
necessary.
W.BAL CONTROL (A:GENERAL)
E AWC SET
R GAIN
B GAIN
SET button
CROSS key
MENU button
AWC OPERATION
.
160
160
AWC OPERATION
(during operation)
Setting/Adjustment
W.BAL CONTROL (A:GENERAL)
E AWC SET
R GAIN
B GAIN 160
AWC OK
AWC OK
(adjustment completed)
E-31
160