Waring Commercial CB15 Serie Mode D'emploi page 12

FOR CB15S AND CB15TS MODELS ONLY:
Hot Blending Lid Instructions
Model number: CBL10
CAUTION
DO NOT BLEND HOT MATERIALS UNTIL BLENDER
AND HOT BLENDING LID ARE CORRECTLY
ASSEMBLED. WHEN BLENDING HOT MATERIALS
ALWAYS FOLLOW THESE INSTRUCTIONS AND
THE INSTRUCTIONS IN THE 4 LITER BLENDER
OPERATING MANUAL.
TO ASSEMBLE:
1. Place lid with gasket over baffle cup and rotate lid
counterclockwise until locking tabs snap into place with
locking tab locks.
2. Place lid, with baffle cup attached, on top of container
and lock with locking clips on container.
Caution – DO NOT COVER ANY HOLES OR OPENINGS
IN THIS LID WHEN HOT BLENDING.
Important – The gasket mounted on the underside of the
hot blending lid is a critical component. If it shows signs of
cuts, tears, cracking, drying out, wear or other deterioration,
it must be immediately replaced before further use. Do not
overfill container; maximum capacity is 4 liters.
TO DISASSEMBLE:
1. Be sure blender is turned off and lid has cooled.
2. Remove container from base.
3. Release locking clips on container and lift lid off.
4. Holding baffle cup, rotate lid clockwise until locking tabs
snap open and lift lid off baffle cup.
12