Napoleon CLEARION Serie Instructions D'installation Et D'opération page 21

Heater
Timer
note:
When only the heat is on (i.e. no flames, no ember bed lights, etc.), the display window will be dim and show H1
as the status.
After the heater is turned off, the blower will continue running for 1 minute. This helps to remove heat from the
appliance and bring down the temperature.
operating instructions
Turns the heater and blower on/off.
Settings:
OFF - Heater and blower off
BL - Blower on
H1 - Heater on (1500W @ 120V and 3000W @ 240V)
H- - Heater and thermostat disabled
(Press and hold the heater button for 5 seconds to disable /
re-enable the heater and thermostat).
Each side of the appliance has an independent heater control.
Sets the timer.
There are 9 timer settings: 0.5h, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h
Note: Display will read 0.0h after completing the 9 timer
settings.
EN
21
W415-1767 / C / 01.29.18