Mounting The Baby Monitor On The Wall - Philips Avent SCD870/26 Mode D'emploi

3 As instructed by the app, hold the WiFi QR code on the screen of
your smartphone or tablet at a distance of around 20 cm in front of
the baby monitor lens. Slowly move the smartphone or tablet closer
or further away from the lens to ensure the WiFi QR is read properly.
When the baby monitor has read the WiFi QR code, it plays a short
tune and the WiFi status light starts to flash green.
4 Follow the on-screen instructions to complete the setup procedure.
5 The WiFi status light turns solid green when the baby monitor is linked
to the WiFi network.
Note: If you are unable to complete the setup procedure and your baby monitor
is not linked to your smart device after you have completed the steps above,
check 'Frequently asked questions' in this user manual for a possible solution.
Tip: For more information on the WiFi status light, see chapter 'WiFi status
light signals'.
6 Next you get an introductory tour through the app.
7 You can then choose between two options: 'Help me mount the baby
monitor' and 'Let me see my baby'.
8 If you choose the first option, you can follow the on-screen
instructions to mount the baby monitor on the wall (see chapter
'Mounting the baby monitor on the wall'). At the end of the on-screen
instructions you can choose 'Let me see my baby'.

Mounting the baby monitor on the wall

The baby monitor comes with a wall mounting bracket. Before you mount
the baby monitor on the wall, make sure there is a good WiFi signal at the
point where you want to mount the baby monitor. Follow the instructions
below to fasten the wall mounting bracket to the wall and to attach the
baby monitor onto the wall mounting bracket.
1 Use a pencil to put a cross on the wall at the place where you want to
mount the baby monitor.
2 Hold the wall mounting bracket to the wall. Make sure that one of the
holes is right over the cross that you put on the wall at step 1.
Note: Make sure that the ring of the wall mounting bracket slants downward
when you hold it to the wall. If the ring of the wall mounting bracket slants
upward, turn the wall mounting bracket the other way around so that it is in
the correct position.
ENGLISH
7