Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
d. Mounting the dust extraction bag (Fig.3)
!
Always connect the dust extraction when sanding.
WARNING
Fig. 3
e. Selecting the speed (Fig.4)
Fig. 4
180615_ayce_NC900BS_IM
• Inhalation of dust particles can
be detrimental to health. The dust
outlet must be connected with a dust
extraction bag.
•
To install the dust extraction bag,
press the ring of the bag and align
the bag with the grooves on the dust
outlet.
•
For longer periods of use or on large
pieces of work, it is advisable to use a
suitable vacuum cleaner.
•
With the speed controller, the rate
of oscillation can be selected (also
during operation). Rotate the speed
controller to choose the suitable
speed.
•
The optimum speed depends on the
material and should be determined
by carrying out a practical test.
•
Stage 1: slow
Stage 6: quick
f. Switch on and off (Fig.5)
Fig. 5
3. Operation for working
Sanding
• The sander can be used for most sanding operations on materials such as wood,
plastic, metal and painted surfaces.
!
Don't use this machine on plaster.
WARNING
• Wear safety goggles and dust mask.
• Where possible, secure smaller work-piece to prevent them from moving under
the sander.
• Lower the sander in contact with the work-piece without pressure and then start
the sander. Move the sander slowly over the surface of the work-piece, for best
results use the sander in a linear motion not circular. Using the sander in a circular
motion may result in the belt tracking slipping. Sand with the grain, in parallel over
lapping strokes.
• To remove paint or smooth very rough wood, sand across the grain at 45º in two
directions, and then finish parallel with the grain.
• Use the front roller only to sand corners or irregular shapes.
84 85
|
Hold the tool firmly to control the twisting
of the tool.
To prolong the life of the tool never
overload it.
1. To start the sander, press the trigger
switch.
2. To stop the sander, release the trigger
switch.
3. If you press the lock on button while
the trigger switch is depressed,
the switch is kept in the operating
position. This is convenient when
continuous operating for extended
periods of time is required.
4. To release the lock on button, press
and release the trigger switch.
NOTE: Always lift the sander from the
work before switching on or switch off.
180615_ayce_NC900BS_IM
GB
GB
Publicité
Table des Matières
