Fein MULTIMASTER FMM 250 Mode D'emploi page 15

M M FMM 250 / M
ULTI ASTER
Round saw blades can be clamped offset
again to provide uniform wear.
Scraping
Typical application: Scraping off old coats of
varnish or adhesives, removing bonded car-
peting, e. g., on stairs/steps or other small/
medium-sized surfaces.
Select a medium to high oscillating frequency.
For further information as well as tips on
polishing, cutting, separating and using as a
rasp, see the booklet "Ideas for Usage".
Maintenance.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Service
Have maintenance carried
WARNING
out only through qualified
personnel. Incorrectly mounted leads and
components can cause serious injuries. Have
the required service carried out only
through a FEIN customer service agent.
Cleaning
Prior to any cleaning or
WARNING
maintenance, disconnect the
power tool from the power supply in order to
avoid accidents. It is best to clean the power
tool with dry compressed air. When clea-
ning power tools with compressed air,
always wear safety goggles.
When working metal under
WARNING
extreme operating conditi-
ons, it is possible for conductive dust to
settle in the interior of the power tool. The
total insulation of the power tool can be
impaired. For such cases, frequent blowing
out the ventilation slots and connecting a
ground-fault circuit interrupter (g.f.c.i.) in
series is recommended.
M FMM 250 Q
ULTI ASTER
Storage
(M
replacing accessories or placing down the
power tool, pull the plug from the socket out-
let. This safety measure prevents accidental
starting of the power tool.
Cooling-air openings and operating ele-
ments must be clean and may not be obst-
ructed through other objects. Do not
attempt to clean the openings with pointed
objects.
Gasoline, carbon-tetrachloride, chloric sol-
vents, ammonia and domestic cleaning
agents that contain ammonia.
lified person using a specially prepared
power cable, available from your FEIN cus-
tomer service agent.
Accessories.
Only use accessories recommended by
FEIN.
M FMM 250 Q - Figure 3).
ULTI ASTER
Before carrying out adjust-
WARNING
ments on the power tool,
➤
Engage the quick-clamping lever.
➤
Fully insert the fastening element
into the tool holder in order to pro-
tect it against damage and contamina-
tion.
Use non-metallic tools to clean the air
vents.
Cleaning agents and solvents can cause
damage to plastic parts. These include:
When the power tool's power cable is
damaged, it must be replaced by a qua-
EN
15