Fein MULTIMASTER FMM 250 Mode D'emploi page 13

M M FMM 250 / M
ULTI ASTER
M M FMM 250 (Figure 4).
ULTI ASTER
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chan-
CAUTION
ging application tools,
always wear protective gloves. Danger of
injury from the sharp edges of the applica-
tion tools. Application tools can become
very hot while working. Danger of burns!
➤
Unscrew the clamping screw.
➤
Clean the tool holder, the applica-
tion tool and the clamping screw.
➤
Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
➤
Tighten the clamping screw using
the supplied Allen key.
Attaching/replacing the sanding sheet (Figure 5).
➤
Align the sanding sheet and press it
onto the sanding plate by hand.
➤
Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and pre-
vents premature wear.
The sanding sheet can be pulled off again
and then remounted offset by 120° when
only one tip of the sanding sheet is worn.
M FMM 250 Q
ULTI ASTER
Fig. 4
Fig. 5
Sanding sheet
Sanding pad
Clamping screw
Tool holder
Allen key
EN
13