Malfunction Analysis - Gree GPC07AK-K3NNA1A Guide D'utilisation

Malfunction Analysis

Please check below items before asking for maintenance. If the malfunction still
can't be eliminated, please contact local dealer or qualified professionals.
Phenomenon
● Power failure?
● Is plug loose?
● Whether the air switch is trip-
Air conditioner
can't operate
● Is there's malfunction for the
● Whether the unit is restarted up
● Is the power too low?
● Whether the air filter is too dirty?
Poor cooling
● Whether the set temperature is
(heating)
● Whether door and window are
● Whether the unit is interfered
● Whether remote controller is
Air conditioner
can't receive
signal from
● Whether it's blocked by obst-
remote contr-
oller or remote
● Is sensitivity of remote contr-
controller is
not sensible.
● Whether there's fluorescence
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Troubleshooting
ped off or fuse is burnt?
circuit?
after stopping immediately?
proper?
closed?
seriously (such as static pres-
sure, unstable voltage)?
within the receiving range?
acles?
oller low?
lamp in the room?
● Wait after power recovery.
● Reinsert the plug.
● Ask professional person to
replace air switch or fuse.
● Ask professional person to
replace circuit.
● Wait for 3min, and then turn
on the unit again.
● Wait after voltage is resumed.
● Clean the air filter.
● Adjust the temperature.
● Close door and window.
● Please pull out the plug. Ins-
ert the plug after about 3min,
and then turn on the unit.
● The receiving range of remote
controller is 8m. Do not exce-
ed this range.
● Remove the obstacles.
● Check the batteries of remote
controller. If the power is low,
please replace the batteries.
● Move the remote controller
close to air conditioner.
● Turn off the fluorescence lamp
and try it again.
13
Solution