Adjustment Of Inside Cradle - Hedson DRESTER GP 24 Manuel Technique

18. Adjustment of inside cradle

1. Place the inside cradle in its outer position and with
the help of a piece of straight metal i.e a ruler, measure
between the ruler and the inside cradle, see picture
below. The measurement should be 157 ± 2 mm.
ruler
2. If the measurement is incorrect, loosen the nut on the
cylinder rod, see picture below. Then try to adjust the
inside cradle by turning the cylinder rod.
Loosen the nut.
3. Check the measurement again. If it´s not possible to
adjust the cradle so the measurement is 157 ±2 mm
in step 2 turn back the cylinder rod and tighten the
nut again.
4. Loosen the four screws and pull out the coupling.
5. Clean the shaft carefully from any grease.
6. Disassemble the coupling and clean all parts.
7. Put a SMALL amount of grease on the surface, stay
3mm inside the edge.
8. Put grease on the threads.
16
Turn the rod to
adjust the cradle.
Grease
9. Assemble the coupling, note the direction of the parts.
Note direction of slots
10. Place the inside cradle in its outer position and
measure the distance, 157 ± 2 mm before tightening
the four screws. The screws should be tightened in
order to 14Nm.
1
4
11. Check that the union between the cylinder and
the pin bolt is greased and can move smoothly.
Otherwise it can seize and lock.
EN
3
2
union.
230756 rev 1