Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16. Adjust the lid
1. Tighten the hose clamps at the front when the swing is
in the correct position.
2. Tighten the rear hose clamps when the swing is in the
correct position.
Aligned with the
edge of roof.
3. Stand behind the machine and tighten the right- hand
screw union according to picture.
14
Tighten from
below.
Aligned with
edge on lid.
Tighten
3-5 mm
4. Lift up the left screw union 2-3 mm and tighten the
screws.
2-3 mm
3-5 mm
5. The upper valve screw should be tightened down
completely and then loosen 1,5 turns. The lower valve
screw should be tightened down completely and the
loosen 6 turns.
EN
upper screw
lower screw
230756 rev 1
Publicité
Table des Matières
