Norcold N2000 Série Manuel D'installation page 17

Connect the power connector with the 12V power connector in the vehicle.
•
For models N2090 and N2152:
It is advised to have the power supply in the vehicle to be routed via the roof. In this
way an over−length of cable is not needed and the power supply cable cannot block
the airways.
For models T2160 and T2175:
Connect the 12V power connector before any furniture is mounted. Make sure that the
12V cable is not trapped between the refrigerator and furniture.
Slide the refrigerator to the back of the furniture.
•
The space holders on the back will stop the fridge at correct position.
Use a screw suitable for below hole dimensions.
•
Table 4: Hole dimensions
A
B
C
Fix the refrigerator in place with the screws, using the pre−drilled positions in the cabinet.
•
15
B
N2090
side side
Ø 0.35in Ø 0.35in
[9mm] [9mm]
0.24in 0.24in
[6mm] [6mm]
Ø 0.16in Ø 0.18in
[4.0mm] [4.5mm]
A
N2152
floor
Ø 0.35in
[9mm]
1.34in
[34mm]
Ø 0.18in
[4.5mm]
N2160/N2175
side floor
Ø 0.35in Ø 0.20in
[9mm] [5mm]
0.24in 0.43in
[6mm] [11mm]
Ø 0.18in Ø 0.20in
[4.5mm] [5mm]